Convert inches to meters with a direct unit conversion factor.
Calculator
Conversion Results
Compare the selected result with metric and US customary length units.
Equivalent Measurements
| Measurement | Value | Calculation note |
|---|
How to convert inches to meters
Multiply the number of inches by 0.0254. The calculator keeps the full conversion factor during the calculation, then formats the displayed answer for readability. Use the direction menu to reverse the conversion without opening another page.
meters = inches x 0.0254
Worked conversion example
For 10 in, multiply 10 by 0.0254. The result is 0.254 m. In reverse, divide a meters value by 0.0254, or multiply it by 39.3700787402.
Common inches to meters conversions
| Inches | Meters | Meters |
|---|---|---|
| 1 in | 0.0254 m | 0.0254 m |
| 3 in | 0.0762 m | 0.0762 m |
| 5 in | 0.127 m | 0.127 m |
| 10 in | 0.254 m | 0.254 m |
| 25 in | 0.635 m | 0.635 m |
| 50 in | 1.27 m | 1.27 m |
| 100 in | 2.54 m | 2.54 m |
Exact length standards
These units share defined relationships: one inch is exactly 0.0254 meter, one international foot is exactly 0.3048 meter, one centimeter is exactly 0.01 meter, and one millimeter is exactly 0.001 meter. The NIST Guide to SI conversion factors documents the inch, foot, and meter relationships used here. Because the factors are defined, rounding comes from the displayed decimal precision rather than an uncertain measurement factor.
When this conversion is useful
Inches and meters commonly appear in product dimensions, construction plans, room measurements, manufacturing specifications, science work, and international forms. Convert every linear dimension before comparing values. For area or volume, do not apply a linear factor only once; square or cube the factor, or use a dedicated area or volume calculator.
Reverse meters to inches
The reverse factor is 39.3700787402. You can select the reverse direction above or use the dedicated meters to inches calculator. Both directions use the same underlying definitions, so equivalent entries produce reciprocal results apart from display rounding.
Precision and rounding
Keep extra decimal places during intermediate work and round only the final answer. A building estimate may need fewer decimals than machining or laboratory work. The calculator also reports meters, centimeters, millimeters, decimal feet, and inches so you can check the result against a familiar unit.
Frequently asked questions
Is the conversion factor exact?
Yes. The result is derived from defined metric prefixes and the exact international inch and foot definitions.
Can I enter negative or decimal values?
Yes. Decimal and negative values are accepted, which is useful for coordinates, offsets, and differences. Physical lengths are normally nonnegative.
Why can the last decimal differ from another calculator?
Calculators may display different numbers of decimal places. Compare the unrounded factor and the precision requested by your source measurement.